And here is the finished stand after Zeke bent the castings from the club shop and bent and brazed the oval tube from the shop.
It fits perfectly!
Thanks to everyone for help along the way

That is really helpful, thank you very much!
The blacksmith is reviewing now so when I get to a stand, I'll post a picture
Again thanks , to all who have helped

Hi .this is the picture I took of the stand i made using the castings that Bruce Harrison had made for the club.
They took a bit of fettling but that was all that was available in 2010.
The width i took from the frame and I bent the legs to clear the exhausts, pattern pipes do not fit like the factory ones. I couldn't get the silencers as close to the wheel as the factory did.
The distance from the pivot I had to measure from the bike as well as the distance from mudguard clip to the pivot point didn't match with anything I had compared to on other bikes.

Many thanks, I'll look out for them

I have some photos of the one I built using the castings the club had..Oval tubing can be bought from Mark Baker, it's the correct eliptical oval tube and not expensive. As soon as i can transfer all my photos to this new computer I'll post them.
John Hood

I am  missing the appropriate rear stand for my 1934/5 Model 9A, which is a twin port and needs the stand which curves out to clear the silencers. My best solution would be if anyone had one which they would be prepared to part with; I would be thrilled to buy it!
But if not, and I have to get one mede, a good set of photos of the stand on and off the frame would be very helpful for the blacksmith I end up getting to make me one
Any help the members can give would be most welcome
Bill Haworth